TechniPrint - Printable Inkjet & Laser Heat Transfer Paper - Light Fabrics - 5pk - A4

Printing Instructions:

1. Preparing Image

• Start with plain paper mode. If toner does not fuse completely or you get lines in your print, adjust your setting to a heavier paper mode like heavy or transparency.
• Mirror the image.This can usually be done within the printer’s property panel.
• Print the image on the blank side of the transfer paper. (Not the side with the text.)
• Paper should be fed into the printer short dimensions first. (grain long)

2. Cut-out Design

• For best results trim the image before applying to garment.

3. Preparing for Transfer:
Heat Press Application (REQUIRED)

• Prepare heat press at 375 degrees F.
• Place heat transfer paper with image facing down in desired position on fabric.
• Using above recommended temperature, apply firm pressure (60 PSI or greater) for 30 seconds.

4. Peel & Wear
Hot peel. Peel the transfer immediately after pressing. (Caution, transfer will be hot.)

• For best result leave on the heat press, wait 10 seconds and then peel the paper in a smooth even motion.
• To improve the feel, stretch garment in all directions while still hot.
• The image can also be softened by covering again with teflon sheet, repressing for 10-15 seconds and immediately stretching it whilst still hot. (Caution, transfer will be hot.)

 Soft Fabric Preferred Method

• Pre-Press for 5-10 seconds
• Place the transfer face down covered by a teflon sheet
• Press for 10-15 seconds at 190 C
• Remove from press and peel the paper AFTER cooling (do not stretch)
• Place garment back on the press covered by a teflon sheet and press again for 25 seconds.
• Remove the teflon sheet and immediately stretch the garment in all directions to soften and improve the durability of the print.
• Washing Instructions:
• Wash inside-out in cold water using a mild detergent. Do NOT bleach. Dry on low-heat setting. Do NOT Iron print.