Doodles - KNK 24 - Maxx Air/Maxx/Eagle - Cutting Strip

This thin cutting strip serves as a replacement to the strip already installed in your machine and is only compatible with the KNK 24" machines (Eagle, Maxx, Maxx Air)

Removing the Old Cutting Strip - Peel off the clear plastic layer from the current cutting strip on your machine and remove the entire adhesive layer. Use rubbing alcohol or other adhesive remover on a cotton swab or paper towel to wipe off any residual adhesive or debris from the cutting strip area.

Applying the New Cutting Strip - Peel back approximately half of the release liner of the new cutting strip and fold it over to the other half of the release liner. Adhere the cutting strip starting from the left side of the machine (adhesive side down) along the front edge of the groove. Make sure to leave a small gap between the cutting strip and the left edge of the groove. Pass the right end of the cutting strip underneath the carriage and then move the carriage to the left-hand side of the machine. Peel off the remaining release liner and then adhere the rest of the cutting strip in the groove. Ensure that the cutting strip is applied so that it continues to lay flat and straight.